Removing and installing oil pump - all engine codes except CJZA, CYVB — AUDI

🧭 Before you start

Fits: Audi A3 (8V, 2012–2020); platform code 85

• Renewed: oil pump

Don't miss

• Renew oil pump if it does not turn easily.

🔧 Engine codes this applies to

📐 45 workshop diagrams for CJZA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove sump (bottom section) .
2. Unclip cover for oil pump drive chain sprocket (arrows).
3. Remove bolts (arrows).
4. Guide out oil pump with drive chain sprocket under drive chain.
5. Check that dowel sleeves (1, 3) are fitted in oil pump.

6. Fit seal with strainer (2) in oil pump.
7. Turn oil pump drive chain sprocket by hand to check oil pump for ease of movement. [Note: Renew oil pump if it does not turn easily.]
8. Fit oil pump with drive chain sprocket into drive chain and secure.
9. Install sump (bottom section) .
10. Fill with engine oil and check oil level 821.

Other AUDI procedures

• Removing engine - engine codes CUKB, CXUA – Audi A3 · 2 torque figures
• Removing and installing fuel tank - vehicles with four-wheel drive · 1 torque figures
• Removing and installing engine support – VW · 3 torque figures
• Removing and installing power and control electronics for electric drive · 3 torque figures
• Checking cooling system for leaks - vehicles with high-voltage system
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures