Removing and installing fuel gauge senderG, front-wheel drive, engine codes CAYD, CAYE, CFHC, CFHE, CFHF, CLCA, CFJA — AUDI
Removing and installing fuel gauge senderG, front-wheel drive, engine codes CAYD, CAYE, CFHC, CFHE, CFHF, CLCA, CFJA on Audi: 15 steps, engines BDJ, BJB.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Caddy III (2K, 2004–2015); platform code 2C0
Don't miss
- Connect connector and ensure secure engagement.
- If the sender cannot be released in this way, the securing tabs (arrows) must also be pushed to the side slightly.
🔧 Engine codes this applies to
📋 Procedure
- Remove fuel delivery unit .
- Release connectors (arrows) and pull off electrical lines (1), (2) and (3).
- Lift securing tabs (4) and (5) using a screwdriver and pull off fuel gauge senderG downwards (arrow).
- Insert fuel gauge senderG into guides on fuel delivery unit and press upwards until it engages.
- Connect connector and ensure secure engagement.
- Install fuel delivery unit .
- Remove fuel delivery unit .
- Pull fuel gauge senderG slightly to side and upwards at the same time.
- If the sender cannot be released in this way, the securing tabs (arrows) must also be pushed to the side slightly.
- Note colour assignment of cables for re-installation.
- Release and pull off electrical connectors (1…3). Then bend back locking lugs of connectors.
- Connect connectors (1…3). Note colour assignment.
- Check connectors are secured properly by pulling.
- Insert fuel gauge senderG into guide on fuel delivery unit and press down until it engages.
- Install fuel delivery unit .
Other AUDI procedures
- Removing and installing fuel tank, four-wheel drive, engine codes CFHC, CFHE, CFHF, CLCA, CLCB, CFJA
- Emptying fuel tank, front-wheel drive, engine codes CAYD, CAYE, CFHC, CFHE, CFHF, CLCA, CLCB, CFJA
- Checking fuel pressure of fuel pump, vehicles with 6.0 bar low pressure fuel system
- Checking glow plugs · 2 torque figures
- Removing and installing engine control unit – Audi A3
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.