Removing and installing fuel gauge senderG, vehicles with front-wheel drive — VW

🧭 Before you start

Fits: VW Golf VII Variant (BA), VW Golf Sportsvan (AM1, 2014–2020), VW Golf VII (5G, 2012–2020)

🔧 Engine codes this applies to

📋 Procedure

1. Remove fuel delivery unit (see the separate procedure).
2. Note colour assignment of cables (1) for re-installation.
3. Release and pull off connectors (1) on sealing flange.
4. Disengage and move clear electrical wiring at retainer (arrow).
5. Release locking lugs (3) and (4) from tabs.

6. Pull out fuel gauge senderG(2) upwards.
7. Bend back the locking hooks of the connectors.
8. Install in reverse order. In the process, note the following:
9. Note colour assignment of contacts.
10. Check connectors are secured properly by pulling.
11. Insert fuel gauge senderG into guide on fuel delivery unit and press down until it engages.
12. Install fuel delivery unit (see the separate procedure).

Other VW procedures

• Removing and installing turbocharger, Sharan
• Removing and installing charge air cooler, Golf, Passat
• Removing and installing radiator cowl – VW Passat B8 · 1 torque figures
• Removing and installing engine mounting – VW
• Removing and installing gearbox mounting – VW Jetta VI
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures