Removing and installing coolant pipes (front) - engine codes CUKB, CXUA — AUDI

🧭 Before you start

Fits: Audi A3 (8V, 2012–2020); platform code 85

• Opens: coolant

Don't miss

• Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.

🔧 Engine codes this applies to

📋 Procedure

1. Remove engine cover panel .
2. Drain coolant .
3. Release hose clip (1) and detach air hose.
4. Remove bolt (2) on both sides.
5. Unclip air duct at lock carrier and detach.

6. Release hose clips (arrows) and disconnect coolant hoses.
7. Remove bolt (1).
8. Move high-voltage wire clear.
9. Remove bolts (1).
10. Release hose clips (arrows) and disconnect coolant hoses.
11. Detach coolant pipes (front). [Note: Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.]
12. Check coolant level .
13. Install engine cover panel .

Other AUDI procedures

• Removing and installing radiator - engine codes CUKB, CXUA
• Removing and installing Hall senders – Audi A3
• Removing and installing throttle valve moduleGX3
• Removing and installing poly V-belt, vehicles with air conditioner compressor · 1 torque figures
• Removing and installing radiator - all engine codes except CUKB, CXUA
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures