Cleaning throttle valve moduleGX3 — VW

🧭 Before you start

Fits: VW Polo 6C (2014–2017); platform code 614

🔧 Engine codes this applies to

📐 34 workshop diagrams for CHPA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Observe safety instructions .
2. Observe rules for cleanliness .
3. Observe repair instructions .
4. Remove throttle valve moduleGX3.
5. Open throttle valve by hand and lock it in open position with a wedge (plastic or wood) (arrow).

6. ⚠ Acetone is highly inflammable.Observe accident prevention regulations and safety notes when handling highly inflammable fluids.Do not use compressed air to clean throttle valve.Wear eye protection and protective clothing to avoid injury and skin contact. — Clean throttle valve housing thoroughly, especially around the points (arrows) where the throttle valve closes, using commercially available acetone and a small brush.
7. Wipe out throttle valve housing with a lint-free cloth.
8. Allow acetone to flash off completely.
9. Install throttle valve moduleGX3.
10. Delete learnt values, and adapt engine control unit J623 to throttle valve moduleGX3.

Other VW procedures

• Removing and installing oil pressure regulating valve N428
• Removing and installing oil spray jets
• Removing and installing exhaust camshaft oil seal, pulley end
• Removing and installing exhaust camshaft oil seal, gearbox end
• Fitting location overview - injection system
• Removing engine · 41 torque figures
• Removing and installing camshaft · 47 torque figures
• Adjusting valve timing · 83 torque figures
• Removing and installing camshafts · 39 torque figures
• Removing and installing coolant pump · 53 torque figures