Removing and installing oil pump up to engine number BTR 004 506 — AUDI
Removing and installing oil pump up to engine number BTR 004 506 on Audi: 17 steps, engines BTR, CCFA, CCFC.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi Q7 (4L, 2005–2015)
- Renewed: gaskets
Don't miss
- Renew gaskets and O-rings.
📋 Procedure
- Remove sump (bottom section) .
- Remove coolant pump .
- Remove bolts (arrows) and detach baffle plate.
- Position used oil collection and extraction unitV.A.G 1782 below engine.
- Remove bolts (arrows) and detach suction pipe.
- Remove bolts (arrows) and take out oil pipe.
- Remove bolts (arrows) and remove oil pump.
- Hold oil pump drive shaft (1) firmly with long-nose grip pliersVAS 6226 and push shaft back against spring pressure. [Note: Renew gaskets and O-rings.]
- Check whether the two dowel sleeves are fitted in the oil pump. Install missing dowel sleeves.
- Hold oil pump drive shaft (1) firmly with long-nose grip pliersVAS 6226 and push shaft back against spring pressure.
- Fit oil pump to sump (top section); insert drive shaft into drive mechanism on oil pump when doing so.
- Release long-nose grip pliersVAS 6226 and let drive shaft (1) slide into oil pump.
- Secure oil pump (arrows).
- Check that drive shaft is positively engaged in oil pump: try to turn oil pump gears by reaching into intake opening (arrow) of oil pump.
- Install coolant pump .
- Install sump (bottom section) .
- Fill with engine oil and check oil level 406.
Other AUDI procedures
- Removing and installing pressure control valve for crankcase breather system
- Removing and installing pressure differential sender G505 or pressure differential sender 2G524
- Removing and installing fuel pump G23, vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine up to 05.2010
- Checking hydraulic valve compensation elements – Audi A6 C6
- Measuring return flow rate of injectors with engine running
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.