Assembly overview - sump, oil pump — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Tighten bolts in sequence (1 to 19) in 2 stages as follows:
2. Tighten bolts to 8 Nm. — 8 Nm (5.9 lb-ft)
3. Turn bolts 45° further
4. Tighten bolts in sequence (1 to 13) in 2 stages as follows:
5. 1. Tighten bolts to 15 Nm. — 15 Nm (11 lb-ft)
6. 2. Turn bolts 90° further.
7. Tighten bolts in the sequence (1 … 9).

Other AUDI procedures

• Removing and installing sealing flange on gearbox side · 6 torque figures
• Checking fuel pressure sender G247 – Audi A1 · 3 torque figures
• Removing and installing vacuum pump – Audi A8 D3 · 2 torque figures
• Assembly overview - cylinder head · 3 torque figures
• Removing and installing ancillary bracket – Audi 2.0 TDI · 1 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures