Removing and installing oil pump from engine number BTR 004 507 onwards — AUDI

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

• Renewed: gaskets

Don't miss

• Renew gaskets and O-rings.

🔧 Engine codes this applies to

📋 Procedure

1. Remove sump (bottom section) .
2. Remove coolant pump .
3. Remove spur gear drive .
4. Remove bolts (arrows) and detach baffle plate.
5. Position used oil collection and extraction unitV.A.G 1782 below engine.

6. Remove bolts (arrows) and detach suction pipe.
7. Remove bolts (arrows) and take out oil pipe.
8. Remove bolts (arrows) and remove oil pump. [Note: Renew gaskets and O-rings.]
9. Check whether the two dowel sleeves are fitted in the oil pump. Install missing dowel sleeves.
10. Install coolant pump .
11. Install sump (bottom section) .
12. Fill with engine oil and check oil level 406.

Other AUDI procedures

• Valve gear - exploded view · 4 torque figures
• Removing and installing fuel system pressurisation pump G6, vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine up to 05.2010
• Removing and installing coolant pipe (rear right) – Audi A3
• Installing high-pressure pipes – Audi A6 C6 · 2 torque figures
• Removing and installing fuel system pressurisation pump G6, vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine from 06.2010 onwards
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures