Removing automatic distance control unit from and installing on retaining plate, variant 2 — VW

🧭 Before you start

Fits: VW Golf VII (5G, 2012–2020)

• Special tools named: VAS 6335

Don't miss

• Renew quick-release fasteners (2).The adjustment screws (1) in the adapter frame are pre-adjusted. Correct the adjustment as required .

📋 Procedure

1. Remove adaptive cruise control unit J428.
2. Turn quick-release fasteners (2) in (direction of arrow).
3. Pull quick-release fasteners (2) off adjustment screws (1).
4. Remove retaining plate (3) from adaptive cruise control unit J428(4). [Note: Renew quick-release fasteners (2).The adjustment screws (1) in the adapter frame are pre-adjusted. Correct the adjustment as required .]
5. Using digital calliper VAS 6335, measure setting (a) of all adjustment screws and correct, if necessary.

6. Set retaining plate (1) on quick-release fasteners (2).
7. Push new quick-release fasteners (2) onto adjustment screws and fixed mounting on adapter frame (3).
8. Turn quick-release fasteners (2) on back of retaining plate (1) to stop in direction of arrow (A).
9. Install adaptive cruise control unit J428.
10. Calibrate adaptive cruise control .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing air conditioning system magnetic clutch N25 from air conditioner compressor
• 5-speed gearbox 085 DS Lupo 3 L, Lupo FSI — Repairing clutch
• Removing and installing fuse holder in front left footwell
• Renewing bottle with tyre sealant – VW
• Checking fuel tank breather: engine code AWC – VW 1.8 AJH/AWC