Checking fuel tank breather: engine code AWC: VW Sharan I / SEAT Alhambra 1.8 (AJH, AWC)

🧭 Before you start

Fits: VW Sharan I / SEAT Alhambra (7M)

Don't miss

• Operate hand vacuum pumpV.A.G 1390 several times. Vacuum must not build up.
• Operate hand vacuum pumpV.A.G 1390 several times. Vacuum must build up.

🔧 Engine codes this applies to

📋 Procedure

1. Pull off breather line (3) from activated charcoal filter system solenoid valve 1N80(1).
2. Connect vacuum testerV.A.G 1368"„connection A“" to activated charcoal filter system solenoid valve 1N80(1).
3. Connect hand vacuum pumpV.A.G 1390 to vacuum testerV.A.G 1368"„connection B“".
4. Set vacuum testerV.A.G 1368 to -A/B- position.
5. Initiate final control diagnosis and select activated charcoal filter system solenoid valve 1N80, 01Performing final control diagnosis.

6. Operate hand vacuum pumpV.A.G 1390 several times. Vacuum must not build up.
7. Check breather hose (4) on activated charcoal canister for soiling and clean if necessary.
8. Seal breather hose (arrow) from activated charcoal canister.
9. Initiate final control diagnosis again and select activated charcoal filter system solenoid valve 1N80, 01Final control diagnosis.
10. Operate hand vacuum pumpV.A.G 1390 several times. Vacuum must build up.
11. Check pressure retention valve .
12. Check breather hose (2) from fuel tank pressure retention valve for leaks.

Other VW procedures

• Checking throttle valve control part
• Checking charge pressure control
• Checking accelerator position sender – VW
• Checking exhaust gas recirculation potentiometer G212 – VW
• Checking Lambda control
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures