Removing and installing fuel gauge senderG, hybrid vehicles — VW

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018); platform codes AV2, AV3

🔧 Engine codes this applies to

📋 Procedure

1. Remove fuel delivery unit .
2. Note colour assignment of cables (1) for re-installation.
3. Release and pull off connectors (1) on sealing flange.
4. Disengage and move clear electrical wiring at retainer (arrow).
5. Release locking lugs (3) and (4) from tabs.

6. Pull out fuel gauge senderG(2) upwards.
7. Bend back the locking hooks of the connectors.
8. Install in reverse order. Observe the following:
9. Note colour assignment of contacts.
10. Check connectors are secured properly by pulling.
11. Insert fuel gauge senderG into guide on fuel delivery unit and press down until it engages.
12. Install fuel delivery unit .

Other VW procedures

• Removing and installing crankshaft pulley · 2 torque figures
• Separating and joining front and rear silencers · 3 torque figures
• Installing engine (Tiguan) – VW 1.4 · 1 torque figures
• Removing and installing air filter housing – VW Golf Cabriolet · 2 torque figures
• Assembly overview - cylinder block, gearbox end · 3 torque figures
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures