Removing and installing engine bracket, Tiguan: VW 2.0 TDI (CBAA, CBAB, CBAC, CBBA, …)

🧭 Before you start

Fits: VW Tiguan I (5N, 2007–2016)

Don't miss

• The assembly mounting may only be removed if the engine is supported with support bracket 10-222A!The engine bracket must be loosened only when the assembly mounting has been removed.
• The securing bolt (1) is accessible through an aperture in the wheel housing. If necessary, raise and lower engine using spindle of support bracket10 - 222 A to remove or start bolts (2) and (3).
• When raising and lowering engine using support bracket10-222A, ensure that no components or hoses are damaged, overstretched or torn off. — Remove securing bolts from engine bracket in sequence (3 … 1).

🔧 Engine codes this applies to

📋 Procedure

1. Remove engine cover panel .
2. Remove intake line between air mass meter G70 and turbocharger.
3. Remove fuel filter Fuel supply - Diesel engines20Fuel filter; Removing and installing fuel filter .
4. Remove supplementary fuel pump V393 or fuel pump 2V277Fuel supply - Diesel engines20Fuel pump; Removing and installing fuel pump.
5. Set up support bracket10 - 222 A with necessary adapters as illustrated and support engine in installation position. [Note: The assembly mounting may only be removed if the engine is supported with support bracket 10-222A!The engine bracket must be loosened only when the assembly mounting has been removed.]

6. Loosen bolts (B). Remove bolts (A) and (C).
7. Unscrew bolts (B) and remove engine assembly mounting.
8. Remove bolt securing coolant line (arrow).
9. Remove front right wheel housing liner General body repairs, exterior66Wheel housing liner.
10. Remove securing bolt of lower coolant line (arrow). [Note: The securing bolt (1) is accessible through an aperture in the wheel housing. If necessary, raise and lower engine using spindle of support bracket10 - 222 A to remove or start bolts (2) and (3).]
11. ⚠ When raising and lowering engine using support bracket10-222A, ensure that no components or hoses are damaged, overstretched or torn off. — Remove securing bolts from engine bracket in sequence (3 … 1).
12. Remove engine bracket upwards.
13. ⚠ The tightening sequence and specified torques for the engine bracket securing bolts must always be followed. Otherwise the engine bracket can be stressed, causing it to break. — Insert engine bracket from above. [Note: The securing bolt (1) is accessible through an aperture in the wheel housing. If necessary, raise and lower engine using spindle of support bracket10 - 222 A to remove or start bolts (2) and (3).]
14. First tighten new securing bolts hand-tight in sequence (1 … 3).
15. Retighten securing bolts in tightening sequence to prescribed specified torque .
16. Position engine assembly mounting and first tighten bolts (A), then (C). Specified torque
17. Bring engine bracket into contact with assembly mounting using spindle.
18. Fit bolts (B) and tighten. Specified torque

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing lock cylinder · 1 torque figures
• Removing and installing backrest cover and padding
• Removing and installing fuel gauge senderG – VW Polo 6C
• Checking delivery pressure – VW Golf V / Jetta
• Alarm system horn H8 (vehicles with power steering) - remove and install · 2 torque figures