Alarm system horn H8 (vehicles with power steering) - remove and install — VW
Alarm system horn H8 (vehicles with power steering) - remove and install on VW: 5 steps, 2 torque figures.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Fox (5Z)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | Loosen the fastening screw(1 |
| 20 Nm (15 lb-ft) | Screw on the fastening screw (1) with torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Turn the ignition and all electric consumers off, and remove the key from ignition.
- Disconnect the BatteryA.
- Disconnect the Alarm system horn H8connector.
- Loosen the fastening screw(1) (20 Nm) and remove the Alarm system horn H8(2). — 20 Nm (15 lb-ft)
- Screw on the fastening screw (1) with torque of (20 Nm). — 20 Nm (15 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Exhaust camshaft seal (gearbox side) - replace
- Steering column switch (SMLS) - E595 - remove and install
- Axle body metal-rubber bearing - replace
- Installing wiper arms – VW Touareg I
- Removing and installing headlight, vehicles 10.99 ▸
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.