Removing and installing coolant pipe for low-temperature cooling circuit — VW

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

🔧 Engine codes this applies to

📋 Procedure

1. Remove engine cover panel
2. Pull front of engine cover panel (1) upwards and remove.
3. Remove noise insulation General body repairs, exterior50Assembly overview - noise insulation.
4. ⚠ Hot steam/hot coolant can escape - risk of scalding.The cooling system is under pressure when the engine is hot.Cover filler cap on expansion tank with a cloth and open carefully to release pressure. — Drain off coolant for low-temperature cooling circuit .
5. Detach coolant hoses (arrows) and remove upper coolant hose (1) from brackets.

6. Unscrew bolts for coolant pipes (1 ... 3).
7. Unscrew bolts (1) and (2) and remove cover panel for high-voltage connection (A).
8. Open securing clips of both quick-release couplings (arrows) and pull off coolant lines.
9. Release vacuum pipe (1) from bracket. Unscrew bolt (2) and pull off coolant hoses (arrows).
10. Remove coolant pipes downwards together with hoses.

Other VW procedures

• Removing and installing coolant pump for low-temperature circuit V468
• Removing and installing coolant pump for high temperature circuit V467
• Removing and installing air filter element – VW Touareg II
• Removing and installing regulating flap control unit J808
• Removing and installing right catalytic converter, bank 1
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures