Removing and installing B-pillar trim, 2-door models — VW
Removing and installing B-pillar trim, 2-door models on VW: 11 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to check.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 121, BL1
- Renewed: if necessary
Don't miss
- Before installing, check all fasteners for damage and renew if necessary.Following installation, ensure that the B-pillar trim is positioned in door seal beading.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | Unscrew bolt (2 |
| 40 Nm (30 lb-ft) | Open cap (1)(arrow) and unscrew bolt (3 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Open cap (1)(arrow) and unscrew bolt (3) (40 Nm). — 40 Nm (30 lb-ft)
- Remove belt guide fitting (2) with belt webbing.
- Release C-pillar trim in area of overlap to B-pillar trim.
- Release side panel trim in area of overlap to B-pillar trim.
- Release B-pillar trim (1) from door seal beading.
- Release B-pillar trim (1) from mountings in area of retaining clips (2), (3), (4) and (5) using removal wedge3409.
- Carefully lift off C-pillar trim in area of overlap to B-pillar trim.
- Carefully lift off side panel trim in area of overlap to B-pillar trim.
- Remove B-pillar trim (1). [Note: Before installing, check all fasteners for damage and renew if necessary.Following installation, ensure that the B-pillar trim is positioned in door seal beading.]
- Insert centring pins (6) into mountings.
- Attach locking lug (1) on sheet metal edge of B-pillar.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Draining cooling system, high-temperature circuit – VW CGEA
- Removing and installing coolant pipe for low-temperature cooling circuit
- Removing and installing high-pressure pipe – VW Touareg II
- Removing and installing right engine support – VW Touareg II
- Removing and installing catalytic converter on right – VW CKDA
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.