Removing and installing right engine support: VW Touareg II (CKDA)

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

🔧 Engine codes this applies to

📋 Procedure

1. Disconnect electrical connector (5) and remove bolt (1).
2. Release hose clips (2) and (4) and take out air pipes (right-side).
3. Remove bolt (1).
4. Release hose clip (arrow) and detach air pipe (right-side) with air hose towards front.
5. Support engine in its installation position .

6. Remove nut (arrow). Raise engine with threaded spindle until engine support (right-side) is positioned above stud of engine mounting (right-side).
7. Remove bolt (1) from right engine support and remove it.
8. Remove nut (arrow). Raise engine using workshop hoist via lifting eye on right-hand side until right-hand engine support is positioned above stud of right-hand engine mounting.
9. Remove bolt (1) from right engine support and remove it.
10. Remove bolts (arrows) and remove engine support on right.

Other VW procedures

• Removing and installing right exhaust manifold – VW Touareg I · 2 torque figures
• Renewing valve stem seals with cylinder head removed – VW CDLJ
• Removing and installing exhaust gas recirculation cooler
• Assembly overview - engine oil cooler, pressure regulating valve for crankcase breather, oil filter housing · 3 torque figures
• Removing and installing drive chain for valve gear – VW
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures