Removing and installing catalytic converter on right: VW Touareg II (CKDA)

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

• Renewed: seals

Don't miss

• Renew seals, gaskets and self-locking nuts.

🔧 Engine codes this applies to

📋 Procedure

1. Remove Lambda probe G39.
2. Remove particulate filter in right .
3. Remove nuts and bolts (arrows) and disengage bracket for noise insulation and remove.
4. Remove subframe Running gear, axles, steering40
5. Remove nuts (arrows) and bolts (1) and remove catalytic converter on right. [Note: Renew seals, gaskets and self-locking nuts.]

6. Mount propshaft on front axle drive Transfer box and axle drives39.
7. Install heat shield for propshaft transfer box and axle drives39.
8. Install bracket for noise insulation 50.
9. Install particulate filter on right .
10. Install Lambda probe G39.

Other VW procedures

• Draining coolant
• Removing and installing sender 1 for turbocharger speed G688
• Measuring return rate of injection units at starter speed
• Testing jammed-open injectors
• Removing and installing exhaust gas recirculation temperature sensor G98
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures