Removing and installing alternator, vehicles with 1.8 l petrol engine and automatic gearbox — VW

🧭 Before you start

Fits: platform code A32

Don't miss

• When batteriesA are disconnected and connected, the procedure described in the workshop manual must always be strictly observed . — Disconnect batteryA.

📋 Procedure

1. ⚠ When batteriesA are disconnected and connected, the procedure described in the workshop manual must always be strictly observed . — Disconnect batteryA.
2. Remove noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
3. Undo nut (2).
4. Remove retainer (1) for wiring harness.
5. Remove bolt (1).

6. Remove air filter housing 24Air filter; Removing and installing air filter housing.
7. Slide down cap (1) in direction of (arrow A).
8. Release and disconnect connector (1).
9. Unscrew nut (3), and remove terminal 30/B+ (2).
10. Undo nut (2).
11. Remove retainer (1) for wiring harness.
12. Remove bolt (1).
13. Remove starterB(2) by taking it upwards out of vehicle.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing AC/DC converter with socket, 12 V - 230 VU13
• Filling, bleeding fuel system – VW Touareg II
• Checking for injectors sticking open – VW 2.0 TDI
• Removing and installing exhaust gas temperature sender 3G495
• Removing undamaged rear side window – VW