Removing and installing starter, 1.6 l petrol engine, 77 kW, automatic gearbox — VW

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018)

📋 Procedure

1. ⚠ When disconnecting or reconnecting the batteryA, adhere strictly to the procedure described in the workshop manual . — Disconnect batteryA.
2. Remove air filter housing 24Air filter; Removing and installing air filter housing.
3. Pull protective cap off solenoid switch in (direction of arrow).
4. Unscrew positive cable (1) and release and detach connector of terminal 50 (2).
5. Remove noise insulation General body repairs, exterior66Noise insulation; Assembly overview - noise insulation.

6. Undo nut (1) and remove it from lower securing bolt of starter.
7. Remove wire holder (2).
8. Remove lower bolt (arrow) of starter.
9. Undo nut (1) and remove it from upper bolt of starter.
10. Remove wire holder (2).
11. Remove upper bolt (arrow) of starter.
12. Undo nut of earth wire (1) and place earth wire (2) to one side.
13. Remove starterB.
14. Tighten threaded connections to specified torque .
15. Reconnect batteryA.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing side member moulding
• Removing and installing roof aerial – VW Jetta VI · 1 torque figures
• 5-speed manual gearbox 02C, four-wheel drive — Renewing needle bearing (polygon bearing) for right output shaft or for right flange shaft
• Replacing number plate light bulb – VW Tiguan I · 2 torque figures
• Removing camshaft housing – VW Golf V / Jetta