Removing and installing starter, 1.8 l petrol engine, 125 kW, automatic gearbox — VW

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018)

Don't miss

• When batteryA is disconnected and connected, the procedure described in the workshop manual must always be strictly observed . — Disconnect batteryA.

📋 Procedure

1. ⚠ When batteryA is disconnected and connected, the procedure described in the workshop manual must always be strictly observed . — Disconnect batteryA.
2. Remove noise insulation General body repairs, exterior66Noise insulation; Assembly overview - noise insulation.
3. Remove nut (2).
4. Remove retainer (1) for wiring harness.
5. Remove bolt (1).

6. Remove air filter housing 24Air filter; Removing and installing air filter housing.
7. Slide back cap (1) in direction of (arrow A).
8. Release and disconnect electrical connector (1).
9. Unscrew nut (3), and remove terminal 30/B+ (2).
10. Remove nut (2).
11. Remove retainer (1) for wiring harness.
12. Remove bolt (1).
13. Remove starterB(2) upwards from vehicle.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Dismantling and assembling hydraulic unit, design stage 3 (ABS)
• Dismantling and assembling hydraulic unit (ABS/EDL)
• Repairing rear brakes, vehicles with disc brakes as of 08.87 and vehicles with ABS
• Repairing TRW power-assisted steering
• Intake manifold - assembly overview