Removing and installing starter, 2.0 l petrol engine, 85 kW, automatic gearbox — VW

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018)

📋 Procedure

1. ⚠ When disconnecting or reconnecting the batteryA, adhere strictly to the procedure described in the workshop manual . — Disconnect batteryA.
2. Remove air filter housing 24Air filter; Removing and installing air filter housing.
3. Pull protective cap off solenoid switch in (direction of arrow).
4. Unscrew positive cable (1) and release and detach connector (terminal 50) (2).
5. Undo nut (1) and remove it from upper bolt of starter.

6. Remove wire holder (2).
7. Remove upper bolt (arrow) of starter.
8. Remove noise insulation General body repairs, exterior66Noise insulation; Assembly overview - noise insulation.
9. Release connectors (arrows) and disconnect.
10. Undo nut (1) and remove it from lower securing bolt of starter.
11. Remove wire holder (2).
12. Remove lower bolt (arrow) of starter.
13. Remove starterB by taking it downwards out of the vehicle.
14. Tighten threaded connections to specified torque .
15. Reconnect batteryA.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing, installing and checking suction jet pump: vehicles with four-wheel drive
• Renewing guide link bushes – VW Phaeton
• Repairing drive shaft with constant velocity joint – VW
• Refitting window motor · 1 torque figures
• Automatic gearbox 01M — Removing and installing oil pan