Automatic gearbox 01M — Removing and installing oil pan — VW

🧭 Before you start

Fits: VW Golf IV / Bora (1J)

Don't miss

• Always renew oil seal (arrow).
• Clean magnet in recess of pan. Ensure that magnet is seated correctly in pan.

📋 Procedure

1. Observe general repair instructions .
2. Remove noise insulation tray.
3. Place drip trayV.A.G 1306 or used oil collection and extraction unitV.A.G 1782 underneath.
4. Remove plug (2).
5. Remove overflow pipe (1) and allow ATF to drain.

6. Unscrew bolts on oil pan in diagonal sequence and remove oil pan.
7. Always renew oil seal (arrow).
8. Clean magnet in recess of pan. Ensure that magnet is seated correctly in pan.
9. Install oil pan with new gasket.
10. Tighten pan bolts diagonally in several stages - bolt.
11. Install and bolt on overflow pipe (1) - overflow tube.
12. Screw in plug (2) hand-tight with new oil seal.
13. Fill with 3 litres of ATF, check ATF level and top up .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing brake pads; Bosch ZOH BIR 38
• Removing and installing front inner door handle · 1 torque figures
• Removing and installing rear inner door handle · 1 torque figures
• Removing and installing middle deformation element · 1 torque figures
• Removing and installing deformation element of C-pillar trim · 1 torque figures