C8,C-Crosser (Brembo brake system) — CITROEN

🧭 Before you start

• Opens: brake fluid

Don't miss

• Bleeding must be done with a diagnostic tool

🔧 Engine codes this applies to

📋 Procedure

1. Raise the vehicle
2. The fluid level should be between MIN and MAX
3. Connect the brake circuit bleeding device to the master cylinder
4. Fill the reservoir
5. Pressurise the system

6. Pressure:
7. Hydraulic reservoir bleeder:
8. Close the circuit
9. Follow the procedure:
10. Open the rear right brake caliper bleed screw
11. Until no bubbles come out
12. Close the bleed screw
13. Collect the escaping fluid in a container
14. Repeat the procedure
15. Rear, left
16. Front, right
17. Front, left
18. Hydraulic reservoir bleeder:
19. Close the circuit
20. Disconnect the brake fluid replacement unit
21. Check the operation of the brake pedal
22. After repairs:
23. Bleed the secondary brake circuit
24. Bleeding must be done with a diagnostic tool
25. Brake fluid:
26. Top up if necessary
27. If required:
28. Bleed the brake system
29. Repeat the procedure

Other CITROEN procedures

• C8,C-Crosser (Lucas brake system)
• 4008 2.0i 4B11
• Peugeot 4007 2.4 4B12 timing chain replacement
• Citroen C-Crosser 2.4 4B12 timing chain replacement
• Citroen C-Crosser W5MBB 2.4 gearbox removal & installation
• Citroen DW10TD timing belt replacement
• Citroen DW10TD timing belt replacement
• Citroen Xantia non turbo 1.9 HDi XUD9A timing belt replacement
• Citroen Xantia turbo timing belt replacement
• Citroen EW10J4/EW7J4 timing belt replacement