Removing and installing fuel gauge sender 2G169 with suction-jet pump, four-wheel drive — AUDI
Removing and installing fuel gauge sender 2G169 with suction-jet pump, four-wheel drive on Audi: 7 steps, 1 torque figure, engines BDJ, BJB, BLS, BMM.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Caddy III (2K, 2004–2015); platform code 2C0
🔧 Engine codes this applies to
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 110 Nm (81 lb-ft) | Tighten locking ring using wrench |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove fuel tank .
- Remove fuel delivery unit .
- Open locking ring using wrench T10202.
- Pull seal and fuel gauge sender 2G169 with suction-jet pump out of opening in fuel tank. Unclip locking lugs (arrows) of suction-jet pump. [Note: Do not bend fuel gauge sender when installing.Insert seal for flange or fuel delivery unit dry into opening of fuel tank.Moisten seal with fuel only when installing flange or fuel delivery unit.Ensure that fuel hose connections are tight.Observe installation position of fuel delivery unit .]
- Tighten locking ring using wrench T10202. Specified torque: 110 Nm. — 110 Nm (81 lb-ft)
- Install fuel delivery unit .
- Install fuel tank .
Other AUDI procedures
- Draining and filling coolant
- Removing and installing fuel tank, four-wheel drive, engine codes CFHC, CFHE, CFHF, CLCA, CLCB, CFJA
- Emptying fuel tank, front-wheel drive, engine codes CAYD, CAYE, CFHC, CFHE, CFHF, CLCA, CLCB, CFJA
- Checking fuel pressure of fuel pump, vehicles with 6.0 bar low pressure fuel system
- Checking glow plugs · 2 torque figures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.