Removing and installing fuel filter, 6.0 bar low pressure fuel system - version A — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

🔧 Engine codes this applies to

📐 39 workshop diagrams for CAYD

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Observe safety instructions .
2. Observe rules for cleanliness .
3. Switch off ignition.
4. Unclip bracket for coolant hose (1).
5. Loosen bolt (1).

6. Remove bolt (2) and nut (3).
7. Then move fuel filter to one side with fuel lines still attached.
8. Unscrew securing bolts (1) to (5).
9. Catch any escaping fuel.
10. Remove fuel filter upper section from fuel filter housing.
11. Move fuel filter upper section to one side with fuel lines still attached.
12. Catch any escaping fuel.
13. Bleed fuel system 24Injection system; Filling/bleeding fuel system

Other AUDI procedures

• Checking fuel filter
• Checking voltage supply and current consumption of fuel system pressurisation pump G6 engine codes BJB, BLS, BSU, BDJ, BST, BMM
• Checking voltage supply and current consumption of fuel supply pump G6, vehicles with 6.0 bar low pressure fuel system
• Testing injectors – VW 2.0 TDI
• Renewing crankshaft oil seal - belt pulley end
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures