Eliminating rear window wiper judder — AUDI

🧭 Before you start

Fits: Audi A4 B5 (8D)

📋 Procedure

1. Switch on ignition.
2. Operate "“rear wiper function”" and allow wiper arm to move to end position.
3. Switch off ignition and take out ignition key.
4. Remove wiper blade.
5. Insert wiper arm (2) in windscreen wiper setting tool3358 B and secure wiper arm with locking screw (3).

6. Compare indicated angle with specified value.
7. Apply open-end spanner (24 mm) (item 1) to windscreen wiper setting tool and adjust wiper arm by twisting as required (arrows).
8. Loosen locking bolt (3) and pull wiper arm (2) out of wiper setting tool.
9. Once again insert wiper arm (2) in windscreen wiper setting tool3358 B and secure wiper arm with locking screw (3).
10. Compare indicated angle with specified value.
11. If necessary, repeat adjusting and checking procedure until specified value is attained.
12. Detach wiper setting tool and fit wiper blade.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Testing the system – Audi A6 C5
• Removing and installing charge air cooler (left-side) – Audi
• Removing and installing intake manifold (left and right bottom sections) - vehicles up to 10.2004
• Renewing engine control unit J623 (master control unit) – Audi
• Removing and installing air mass meter 2G246 (cylinder bank 2)