Removing and installing left rear window wiper motor, vehicles with rear wing doors — AUDI
Removing and installing left rear window wiper motor, vehicles with rear wing doors on Audi: 13 steps.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)
Don't miss
- Make sure that seal (1) is properly seated in installation aperture of wing door.
📋 Procedure
- Remove rear window wiper arms .
- Remove lower rear wing door trim General body repairs, interior70Door trims;.
- Remove assembly carrier General body repairs, exterior58Central locking for rear doors, sliding door, wing doors; Rear wing doors; Removing and installing assembly carrier.
- Remove hose (1) from window washer system.
- Release and disconnect connector (3).
- Remove securing bolts (arrows).
- Remove rear window wiper motor (2).
- If necessary, unbolt rear window wiper motor from bracket (arrows).
- Make sure that seal (1) is properly seated in installation aperture of wing door.
- ⚠ Before inserting rear right wing door window wiper motor V93, moisten rear window wiper arm shaft with lubricant polyethylene glycol. — Insert rear left wing door window wiper motor V92.
- Screw in and tighten securing bolts (arrows). Specified torque: Assembly overview - rear window wiper system, vehicles with rear wing doors
- Install lower rear wing door trim General body repairs, interior70Door trims;.
- Install rear window wiper arms .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing covers and padding of seats in 1st row
- Removing and installing handbrake cable, Caddy 2011 ▶
- Removing and installing radio navigation system "“RNS 510”", all other vehicle models
- Repairing rear heating and air conditioning unit
- Removing and installing left stub shaft, 5-speed manual gearbox
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.