Removing and installing front window regulator motor — VW
Removing and installing front window regulator motor on VW: 10 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes A32, A33
Don't miss
- New window regulator motor must be coded using the vehicle diagnosis, testing and information systemVAS 5051B.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 3 Nm (2.2 lb-ft) | Install bolts (3 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove front door trim General body repairs, interior70Front door trims; Removing and installing front door trim.
- Secure door window against sliding down with adhesive tape.
- ⚠ Switch off ignition and all electrical consumers.Remove ignition key. — Disconnect connector (3).
- Remove bolts (2) (Qty. 3).
- Remove window regulator motor together with control unit (1) from mounting brackets.
- ⚠ If a new window regulator motor is installed (door control unit), the additional functions and the excess force limitation feature have to be coded! — Position window regulator motor (1) on mounting brackets of cable drum. Move door window up and down slightly so that the splines between window regulator motor and cable drum engage more easily.
- Screw in bolts (2) (Qty. 3).
- Connect connector (3).
- New window regulator motor must be coded using the vehicle diagnosis, testing and information systemVAS 5051B.
- The work procedure and notes on the automatic window raising and lowering system as well as on the excess-force limitation feature can be found in .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing cover cap (without lock cylinder)
- Removing and installing alternator, vehicles with 1.8 l petrol engine
- Removing and installing refrigerant line between condenser and air conditioner compressor
- Removing and installing refrigerant line between air conditioner compressor and expansion valve, petrol
- Removing and installing belt pulley, Denso air conditioner compressor
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.