Removing and installing window regulator motor V14/V15: VW Passat B8

🧭 Before you start

Fits: VW Passat B8 (3G, 2014–)

Don't miss

• A new window regulator motor must be coded using .

📋 Procedure

1. Remove rear door trim General body repairs, interior70Rear door trims; Removing and installing rear door trim.
2. Secure door window against sliding down with adhesive tape.
3. Switch off ignition and all electrical consumers. Remove ignition key.
4. Disconnect connector (2).
5. Remove bolts (4) (Qty. 3).

6. Remove window regulator motor (1) from mounting brackets of cable drum (3).
7. Slot window regulator motor (1) onto mounting brackets of cable drum (3). Move door window up and down slightly so that the splines between window regulator motor and cable drum engage more easily.
8. Tighten bolts (4).
9. Connect connector (2).
10. A new window regulator motor must be coded using .
11. The work procedure and notes on the automatic window raising and lowering system as well as on the excess-force limitation feature can be found in .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures