Removing and installing left rear wing door window wiper motor V92, vehicles with rear wing doors — AUDI

🧭 Before you start

Fits: platform codes SF, SG

Don't miss

• Make sure that seal (1) is properly seated in installation aperture of wing door.

📋 Procedure

1. Remove rear window wiper arms .
2. Remove lower trim of rear wing door General body repairs, interior70Luggage compartment trim; Overview of fitting locations – luggage compartment trim.
3. Remove assembly carrier General body repairs, exterior58Door components; Removing and installing assembly carrier.
4. Remove hose (1) from window washer system.
5. Release and disconnect connector (3).

6. Remove securing bolts (arrows).
7. Remove rear window wiper motor (2).
8. If necessary, unbolt rear window wiper motor from bracket (arrows).
9. Make sure that seal (1) is properly seated in installation aperture of wing door.
10. ⚠ Before inserting the rear left wing door window wiper motor V92, moisten the wiper arm shaft with polyethylene glycol lubricant. — Install assembly carrier General body repairs, exterior58Door components; Removing and installing assembly carrier.
11. Install lower trim of rear wing door General body repairs, interior70Luggage compartment trim; Overview of fitting locations – luggage compartment trim.
12. Install rear window wiper arms .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures