Adjusting fixed rear door window: VW Passat CC / CC
Step-by-step adjusting fixed rear door window for the VW Passat CC / CC: 8 steps, 2 torque figures. What to remove, what to tighten and to how many Nm.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat CC (357, 2008–2012), VW CC (358, 2012–2017)
Don't miss
- Loosen bolts (4 and 5), do not unscrew completely.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 6 Nm (4.4 lb-ft) | Tighten bolts (4 and 5) to specified torque |
| 9 Nm (6.6 lb-ft) | Tighten bolts (4 and 5) to specified torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Pull out plug at bottom and fold window slot seal to side.
- Loosen bolts (4 and 5), do not unscrew completely.
- Adjust door window in height (arrow b).
- Tighten bolts (4 and 5) to specified torque of 9 Nm. — 9 Nm (6.6 lb-ft)
- Pull out plug at bottom and fold window slot seal to side.
- Loosen bolts (4 and 5), do not unscrew completely.
- Adjust inclination of door window (arrow a).
- Tighten bolts (4 and 5) to specified torque of 6 Nm. — 6 Nm (4.4 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing ceramic glow pin plugs; carrying out resistor test · 2 torque figures
- Removing and installing C-pillar trim, 2-door models – VW · 2 torque figures
- Removing and installing exterior mirror, manually operated · 2 torque figures
- Draining and filling with coolant, Polo – VW CHZB/CHZC
- Removing and installing ABS control unit J104/ABS hydraulic unit N55, vehicles with 4-cyl. petrol engine
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.