Eliminating wiper blade judder — AUDI

🧭 Before you start

Fits: Audi A4 B5 (8D)

📋 Procedure

1. Switch on ignition.
2. Operate "“touch-wipe function”" and allow wiper arms to move to end position.
3. Switch off ignition and take out ignition key.
4. Remove wiper blade .
5. Insert wiper arm (2) in windscreen wiper setting tool3358 B and secure wiper arm with locking screw (3).

6. Compare indicated angle with specified value.
7. Apply open-end spanner (24 mm) (item 1) to windscreen wiper setting tool and adjust wiper arm by twisting as required (arrows).
8. Loosen locking screw (3) and pull wiper arm (2) out of windscreen wiper setting tool.
9. Once again insert wiper arm (2) in windscreen wiper setting tool3358 B and secure wiper arm with locking screw (3).
10. Compare indicated angle with specified value.
11. If necessary, repeat adjusting and checking procedure until specified value is attained.
12. Detach windscreen wiper setting tool and fit wiper blade .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing expansion valve with refrigerant shut-off valve 2 for hybrid battery N517
• Cleaning evaporator in front and rear air conditioning unit with ultrasonic A/C cleanerVAS 6189A
• Removing, installing and checking auxiliary air heater element Z35 with auxiliary air heater control unit J604
• Removing and installing fuse holder FSF in luggage compartment - vehicles up to model year 2013 and all vehicles with high-voltage system
• Removing and installing front seat - standard seat/multi-contour seat