Adjusting wiper blade park position — AUDI
Adjusting wiper blade park position on Audi: 3 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes S1, 2H
Don't miss
- Allow windscreen wiper system to operate in wipe/wash function as a test. When doing this, make sure that wiper blades do not strike against upper or lower end positions. If necessary, correct wiper blade end position again.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | Tighten securing nuts of wiper arms |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Adjust wiper arms so that ends of wiper blades are located on windscreen in area of markings (A) or (B).
- Tighten securing nuts of wiper arms to 20 Nm. — 20 Nm (15 lb-ft)
- Allow windscreen wiper system to operate in wipe/wash function as a test. When doing this, make sure that wiper blades do not strike against upper or lower end positions. If necessary, correct wiper blade end position again.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing injection pump: engine codeAFF, AHU, AFN,AVG
- Removing and installing the injection pump Engine codes: AFF, AHU, AFN
- Dismantling and assembling drive pinion
- Checking electric additional heater
- Renewing engine control unit with protective housing
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.