Eliminating rear wiper judder — AUDI
Eliminating rear wiper judder on Audi: 12 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C5 (4B)
📋 Procedure
- Switch on ignition.
- Switch wiper on and off and allow to move to end position.
- Switch off ignition and remove ignition key.
- Detach wiper blade.
- Place the wiper arm (2) in the wiper adjusting tool3358 B and secure the wiper arm with the locking screw (3).
- Compare angle displayed to specification.
- Apply 24 mm open-ended wrench (Item 1) to adjusting tool and move wiper arm (2) to specified position (arrows).
- Slacken off locking screw (3) and pull wiper arm (2) out of adjusting tool.
- Place the wiper arm (2) in the wiper adjusting tool3358 B again and secure the wiper arm with the locking screw (3).
- Compare the angle displayed to the specification.
- If necessary, repeat the setting and checking procedure until the specification is attained.
- Detach the adjusting tool and fit the wiper blade.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Assessing wear on chain, pulley sets "“I”" and "“II”", bearing "“C”" and suction-jet pump
- Removing and installing rear flange shaft, oil seal and ball bearing
- Dismantling and assembling differential, front-wheel drive
- Renewing brake caliper (1LA/1LJ/1ZB/1ZT) – Audi Q5
- Renewing brake caliper (1LB/1LC/1LE/1LP) – Audi Q5
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.