Eliminating wiper judder - vehicles up to Model Year 2001 — AUDI

🧭 Before you start

Fits: Audi A2 (8Z)

📋 Procedure

1. Switch on ignition.
2. Actuate the "“Flick wipe”" function and allow the wiper arm to move to its end position.
3. Switch off ignition and take out ignition key.
4. Detach wiper blade (see the separate procedure).
5. Place the wiper arm (1) in the wiper adjusting tool 3358 A and secure the wiper arm with the locking screw (2).

6. Compare indicated angle with specified value.
7. Place the A/F 24 open-ended spanner (Item 3) on the wiper adjuster and adjust the wiper arm (1)(arrows).
8. Loosen the locking bolt (2) and pull the wiper arm (1) out of the wiper adjuster device.
9. Reinsert the wiper arm (1) in the wiper adjuster 3358 A and fasten in position again with the locking bolt (2).
10. Compare indicated angle with specified value.
11. If necessary, repeat adjusting and checking procedure until specified value is attained.
12. Detach adjustment tool and fit wiper blade.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing evaporator output temperature sender G263
• 6-speed manual gearbox 02Q, front-wheel drive — Bleeding clutch system
• Removing and installing clutch (LuK version) – Audi A3
• Removing and installing electrical radiator fan V7 and radiator fan 2V177
• Removing and installing automatic glow period control unit J179