Removing and installing evaporator output temperature sender G263 — AUDI

🧭 Before you start

Fits: Audi A5 (8T, 2007–2016), Audi Q5 (8R, 2008–2017), Audi A5 Cabriolet (8F), Audi A4 B8 (8K, 2007–2015); platform code 83

• Special tools named: VAS 5051

📋 Procedure

1. Move front passenger's seat to rearmost position.
2. Switch off ignition.
3. Remove glove box General body repairs, interior68Shelves / trim panels; Removing and installing glove box.
4. Remove right footwell vent (front passenger's side) .
5. Unplug connector (A).

6. Release evaporator output temperature sender G263(B) from mounting (C) of air conditioning unit.
7. Turn evaporator output temperature sender G263(B) 180° and pull it out of air conditioning unit. [Note: Evaporator output temperature sender G263(B) is installed with temperature sensor (D) facing evaporator. To make it possible to remove and install it with the air intake box in position, it must be turned in its mounting by 180° from its installation position after detaching / before attaching.]
8. Insert evaporator output temperature sender G263(B) in mounting (C) of air conditioning unit.
9. Turn evaporator output temperature sender G263(B) 180° and then secure it in mounting.
10. Re-install all parts removed in reverse order.
11. Switch on ignition.
12. Interrogate event memory of operating and display unit (Climatronic control unit J255) and erase any faults displayed Vehicle diagnostic, testing and information system VAS 5051 ("Guided Fault Finding").

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures