Vehicles with 1.4 l TSI engine and dual clutch gearbox — VW
Vehicles with 1.4 l TSI engine and dual clutch gearbox on VW: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touran I (1T, 2003–2015)
📋 Procedure
- Disconnect battery .
- Release vacuum hose (arrow) and pull it off.
- First pull off engine cover upwards from its rubber mountings (1) and then remove it forwards in direction (of arrow).
- Remove air filter housing Engine mixture preparation24Repairing injection system; Removing and installing air filter.
- Release and disconnect connector (1).
- Slide protective cap (1) off solenoid switch in direction of (arrow).
- Unscrew securing nut (1) and remove positive wire (2) from connector thread of solenoid switch.
- Remove securing nut (arrow) and place earth wire aside.
- Remove upper securing bolt of starter (arrow).
- Unscrew lower securing bolt (2) and remove starter (1) upwards from vehicle.
- Tighten threaded connections to specified torques .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing alternator, 1.2 l 40 kW or 47 kW injection engine
- Removing and installing alternator, 1.8 l 110 kW turbo engine
- Brake system — Removing and installing Handbrake cable (disc brake)
- 4-speed automatic transmission 001 — Removing and installing valve chest
- Removing and installing brake drums and shoes
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.