Removing and installing starter, 1.4 l, 103 kW or 125 kW TSI engine with dual clutch gearbox (DSG) DQ200-7F — VW

🧭 Before you start

Fits: VW Touran I (1T, 2003–2015)

📋 Procedure

1. Disconnect battery .
2. Release vacuum hose (arrow) and pull off.
3. First, pull engine cover panel upwards off its rubber mountings (1), then remove it forwards (direction of (arrow)).
4. Remove air filter housing Power unit24Repairing injection system; Removing and installing air filter.
5. Release connector (1) and disconnect.

6. Push protective cap (1) off solenoid switch downwards in direction of (arrow).
7. Undo nut (1) and take positive wire (2) off thread of solenoid switch.
8. Unscrew securing nut (arrow), and move earth wire to side.
9. Remove upper securing bolt of starter (arrow).
10. Unscrew lower securing bolt (2) of starter and remove starter (1) upwards from vehicle.
11. Tighten threaded connections to specified torque given in assembly overview .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Adjusting valve timing (installing timing chains) – VW 2.3 AZX · 7 torque figures
• Removing and installing door · 8 torque figures
• Removing and installing defroster flap control motor V107 · 9 torque figures
• Removing and installing turbocharger 1 control unit J724 · 6 torque figures
• Pressing sealing flange with sender wheel onto crankshaft · 6 torque figures