Removing and installing starter, 1.4 l, 118 kW TSI engine, dual clutch gearbox (DSG) DQ200-7F — VW

🧭 Before you start

Fits: platform code 521

📋 Procedure

1. Disconnect battery .
2. Pull off engine cover upwards from its rubber mountings (1) and remove it in (direction of arrow).
3. Remove air filter housing Engine mixture preparation24Repairing injection system; Removing and installing air filter.
4. Release and disconnect connector (1).
5. Slide protective cap (1) off solenoid switch in direction of (arrow).

6. Unscrew securing nut (1) and remove positive wire (2) from connector thread of solenoid switch.
7. Remove upper securing bolt of starter (arrow).
8. Remove lower securing bolt of starter (arrow).
9. Remove starter upwards out of vehicle.
10. Tighten threaded connections to torques specified in assembly overview .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing air recirculation flap control motor V113
• Removing and installing pressure differential sender G505
• Removing and installing glow plugs
• Removing and installing C-pillar trims – VW · 1 torque figures
• Installing control unit and hydraulic unit – VW Golf IV / Bora · 1 torque figures