Renewing crankshaft oil seal - timing chain end: VW Touareg II 3.0 TDI (CASA, CASD, CATA, BKS, …)

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

🔧 Engine codes this applies to

📋 Procedure

1. Remove drive plate .
2. Lever oil seal out using lever T20143/2.
3. Modify assembly sleeve T10122/2 by drilling an 8 mm ∅ hole (arrow 2) for the dowel sleeve.
4. Use hole (arrow 1) in washer as a drilling template.
5. Clean running surface and sealing surface.

6. Fit guide sleeve T10122/1 onto assembly sleeve T10122/2 and slide oil seal (A) onto assembly sleeve.
7. Remove guide sleeve.
8. Fit assembly sleeve with oil seal onto crankshaft.
9. Press in oil seal uniformly until flush all round using press sleeve T10122/3.
10. Install drive plate .

Other VW procedures

• Removing and installing thermostat with union (engine codes CASA and CASD) · 1 torque figures
• Checking return flow rate of injectors (piezo injectors) with engine running.
• Removing and installing lower part of right intake manifold
• Removing and installing turbocharger (engine codes CASA, CASB, CASC)
• Removing and installing timing chain cover (left) – VW 3.0 TDI
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures