Renewing crankshaft oil seal (timing chain end): VW Touareg I 3.0 TDI (BKS, BUN, CASA, CASB, …)

🧭 Before you start

Fits: VW Touareg I (7L, 2002–2010)

🔧 Engine codes this applies to

📐 9 workshop diagrams for BKS

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove drive plate (see the separate procedure).
2. Lever oil seal out using lever T20143/2.
3. Modify assembly sleeve T10122/2 by drilling an 8 mm ∅ hole (arrow 2) for dowel sleeve.
4. Use hole (arrow 1) in washer as a drilling template.
5. Clean running surface and sealing surface.

6. Fit guide sleeve T10122/1 onto assembly sleeve T10122/2 and slide oil seal (A) onto assembly sleeve.
7. Remove guide sleeve.
8. Fit assembly sleeve with oil seal onto crankshaft.
9. Press in oil seal uniformly until flush all round using press sleeve T10122/3.
10. Install drive plate (see the separate procedure).

Other VW procedures

• Removing and installing intake manifold flap motor V157 or intake manifold flap motor 2V275 (engine codes BKS, BUN)
• Removing and installing fuel pressure sender G247 · 1 torque figures
• Removing and installing fuel pressure regulating valve N276 · 1 torque figures
• Assembly overview - exhaust manifold with intermediate pipe · 2 torque figures
• Removing and installing right coolant pipe – VW Touareg I
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures