Renewing crankshaft oil seal on timing chain end: VW Touareg I (BAR, BMK, CARA, CEXA, …)

🧭 Before you start

Fits: VW Touareg I (7L, 2002–2010)

• Special tools named: T20143/2, T10122/1, T10122/2, T10122/3

🔧 Engine codes this applies to

📋 Procedure

1. Remove engine .
2. Separate engine and gearbox .
3. Secure engine to engine and gearbox supportVAS 6095.
4. Remove drive plate .
5. Prise out oil seal using extractor tool T20143/2.

6. Clean running surface and sealing surface.
7. Fit assembly aid T10122/1 onto assembly sleeve T10122/2 and slide oil seal (A) onto assembly sleeve.
8. Remove assembly aid.
9. Fit the assembly sleeve T10122/2 with oil seal (1) onto crankshaft.
10. Press oil seal in evenly with T10122/3 until flush.
11. Install drive plate .
12. Install engine .

Other VW procedures

• Removing and installing radiator fans
• Removing and installing accelerator pedal module with accelerator position sender
• Removing and installing main catalytic converter (left-side)
• Removing and installing main catalytic converter (right-side)
• Renewing oil seals for auxiliary drives – VW Touareg I 4.2 BAR
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures