Removing and installing mounting plate for engine oil cooler, pressure control valve and oil filter housing — AUDI
Removing and installing mounting plate for engine oil cooler, pressure control valve and oil filter housing on Audi: 18 steps, engines ASB, BKN, BMK, BNG.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B6/B7 (8E)
- Opens: coolant
- Renewed: gaskets
Don't miss
- Renew gaskets, seals and O-rings.
🔧 Engine codes this applies to
📐 20 workshop diagrams for ASB
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Drain off coolant .
- Remove intake manifold (top section) 23.
- Remove bottom section of intake manifold (left and right) 23.
- Remove coolant pipe (rear) .
- Remove toothed belt for high-pressure pump 23.
- Remove high-pressure pump 23.
- Remove exhaust gas recirculation cooler .
- Remove bolts (1 ... 8).
- Take out mounting plate with engine oil cooler, pressure control valve and oil filter housing. [Note: Renew gaskets, seals and O-rings.]
- Tighten bolts securing mounting plate from the inside outwards.
- Install exhaust gas recirculation cooler .
- Install high-pressure pump 23.
- Install toothed belt for high-pressure pump 23.
- Install coolant pipe (rear) .
- Install bottom section of intake manifold (left and right) 23.
- Install intake manifold (top section) 23.
- Fill up with engine oil and check oil level 803 or 805.
- Fill cooling system .
Ask TorqFix about your Audi ASB — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your Audi ASB — free → or sign up free to see the drawingsOther AUDI procedures
- Removing and installing exhaust gas temperature sender 1G235 · 1 torque figures
- Removing and installing drive chain for valve gear – Audi · 1 torque figures
- Checking radial clearance of conrod bearings – Audi A4 B5 · 6 torque figures
- Removing and installing cylinder head cover – Audi TT Mk1
- Removing and installing oil filter housing – Audi A8 D3
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.