Removing and installing starterB, 1.4 l TSI engine, 90 kW, manual gearbox MQ200-6F — VW

🧭 Before you start

Fits: VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014)

📋 Procedure

1. Disconnect battery .
2. Remove air filter housing 24Air filter; Removing and installing air filter housing.
3. Release connector (1) and disconnect.
4. Push protective cap (1) off solenoid switch downwards in direction of (arrow).
5. Undo nut (1) and take positive wire (2) off thread of solenoid switch.

6. Undo nut (1) from upper securing bolt of starter and remove earth cable (2).
7. Remove upper securing bolt of starter, lies behind.
8. Remove noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
9. Undo nuts (1).
10. Remove cable retainer (2) from lower securing bolt of starter.
11. Undo alternator bolt at bottom (2).
12. Remove starter (1) by taking it downwards out of the vehicle.
13. Tighten threaded connections to specified torque given in assembly overview .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing shock absorbers, multi-link suspension
• Removing and installing rear lid, Cabriolet
• Removing and installing dash panel cover on front passenger side, cover with storage compartment
• Checking oil pressure and oil pressure switch (engine codes CBFA, CCTA)
• Removing Bowden cables for sun visor