Removing Bowden cables for sun visor — VW

🧭 Before you start

Fits: platform code 1F7

📋 Procedure

1. Only loosen the end eye of the outer tensioning strap on the main hinge .
2. Remove tensioned headlining without releasing tensioning straps .
3. Remove bracing hoop for tensioned headlining .
4. Open roof using convertible roof actuation button until just before illustrated position.
5. Insert pin (2) in lowest position of hinge supportVAS 6365.

6. Insert hinge supportVAS 6365 into mounting hole in main hinge (1) and turn foot (4) so that it does not engage in opening in longitudinal member.
7. Switch ignition off; the roof will lower in stages until the supports contact the longitudinal member.
8. Unscrew bolts (1).
9. Remove cover (2) and remove intermediate shaft (3) from mounting bracket (4).
10. Pull sliding headliner (3) out approx. 10 cm.
11. Pull sliding headliner (3) Bowden cables (2) out of rear guide rails (1).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing engine control unit J623 and engine control unit 2J624
• Removing and installing right indirect ventilation flap control motor V453 · 1 torque figures
• Removing and installing thermostat with union (engine code CATA) · 1 torque figures
• Removing and installing Hall sender G40 – VW
• Removing and installing lower part of intake manifold with fuel rail