Removing and installing starter, vehicle with automatic gearbox AQ450 — VW

🧭 Before you start

Fits: VW Tiguan I (5N, 2007–2016)

📋 Procedure

1. ⚠ To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to . — Disconnect battery .
2. Remove air filter Power unit24Removing and installing air filter.
3. Release connector (1) and pull off.
4. Push protective cap (1) downwards off solenoid switch in (direction of arrow).
5. Unscrew securing nut (1) and remove positive cable (2) from connecting thread of solenoid switch.

6. Unscrew and remove upper securing nut (1) of cable retainer (2).
7. Remove noise insulation General body repairs, exterior50Body front; Noise insulation.
8. Unscrew and remove lower securing nut (2) of cable retainer and pull cable retainer (1) off starter securing bolts.
9. Remove lower securing bolt of starter (arrow).
10. Remove upper securing bolt of starter (arrow).
11. Remove starter upwards from vehicle.
12. Tighten all threaded connections to torque specified in assembly overview .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing valve body – VW Golf IV / Bora
• Removing and installing brake servo, engine code CJLA – VW
• Removing and installing valve stem oil seals
• Separating backrest cover from backrest padding
• Removing and installing belt anchor rail – VW Golf Cabriolet · 2 torque figures