Removing and installing rear lid trim 06.00 ▸: VW Sharan I / SEAT Alhambra
Step-by-step removing and installing rear lid trim 06.00 ▸ for the VW Sharan I / SEAT Alhambra: 11 steps.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan I / SEAT Alhambra (7M)
📋 Procedure
- Remove trim frame for rear lid ▸ 06.00
- Lever out caps
- Remove cross-head screws
- Lever out caps
- Remove cross-head screws
- Swing out trim in lower area slightly and pull out upwards off clips
- Fit trim panel in clips
- Clip in trim
- Secure trim with cross-head screws
- Clip in cap
- Install trim frame for rear window 06.00 ▸
Other VW procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.