Adjusting height of rear lid: VW Sharan I / SEAT Alhambra
Step-by-step adjusting height of rear lid for the VW Sharan I / SEAT Alhambra: 11 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan I / SEAT Alhambra (7M)
Don't miss
- Pull down rear section of moulded headliner to loosen and tighten bolts. In doing so, do not kink the headliner.
- Loosen hexagon nuts (1) of the hinges in the rear of the roof cross member (do not unscrew completely).
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 23 Nm (17 lb-ft) | Have a second mechanic lift rear lid so that outer contour (arrows) is aligned and… |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove upper D-pillar trim General body repairs, interior70Trims, insulation; Pillars and side trims.
- Pull down rear section of moulded headliner to loosen and tighten bolts. In doing so, do not kink the headliner.
- Remove gas-filled strut for rear lid: .
- Unscrew the cross-head screw (2) on the left and right and then remove cover for guide pins (1).
- Unscrew left and right guide pins.
- Loosen hexagon nuts (1) of the hinges in the rear of the roof cross member (do not unscrew completely).
- Have a second mechanic lift rear lid so that outer contour (arrows) is aligned and tighten hexagon nuts of hinges to 23 Nm. — 23 Nm (17 lb-ft)
- Check gaps and shut lines with gauge 3371 and adjust 00Technical data; Body gap and shut line dimensions; Body - rear.
- Tighten left and right guide pins.
- Install gas-filled struts.
- Adjust guide pins .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing fresh air blower V2, RHD vehicles – VW
- Removing and installing coolant pipes for auxiliary/supplementary heater
- Removing automatic distance control unit from and installing on retaining plate, variant 2
- Removing and installing onboard supply control unit J519, RHD vehicles
- Removing and installing air mass meter G70/intake air temperature sender G42
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.