Adjusting height of trim B — VW
Adjusting height of trim B on VW: 8 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 9C1, 1C1, 1Y7
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 3 Nm (2.2 lb-ft) | Tighten screws (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove side panel trim .
- Remove main frame for flap modules and . (7)
- Remove screws (1).
- The height and tilt angle in areas (A), (B) and (C) are adjusted by screwing screws (1), (2) and (3) in or out.
- Tighten screws (1) (3 Nm). — 3 Nm (2.2 lb-ft)
- Install main frame for flap modules and . (7)
- Check trim height (B) and adjust again, if necessary.
- Install side trim panel .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- 5-speed manual gearbox 01A, all-wheel drive — Renewing oil seals for flange shafts
- Renewing speedometer drive wheel – VW Passat B5
- Checking chain tensioner for oil pump and removing and installing oil pump
- Removing and installing suction jet pump – VW 2.3 AGZ
- Checking electronically controlled cooling system – VW 1.6 AVU
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.