Removing and installing left trim on seat with manual height adjustment — VW

🧭 Before you start

Fits: VW CC (358, 2012–2017)

Don't miss

• For greater clarity, the retaining clip is shown removed in the illustration.
• When pulling the trim off, make sure that the retainer (5) and lug (2) are not damaged.
• Ensure that the lug (2) is seated correctly.Make sure that the trim (1) has engaged correctly on the retainer (3) and that the lockable clips (4) are closed.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Pull height adjustment handle (3) upwards and press metal tab of retaining clip (1) inwards using a small screwdriver. Pull height adjustment handle (3) off adjusting lever (2). [Note: For greater clarity, the retaining clip is shown removed in the illustration.]
2. Remove retaining clip (1) from adjusting lever (2).
3. In seats with manual backrest adjustment turn backrest adjustment wheel (1) until you can see catch from rear (arrow A). If necessary, use a torch for this.
4. Turn backrest adjustment wheel (1) until a fastener can be seen from the rear (arrow A). If necessary, use a torch for this.
5. Hook assembly tool3399 in and lever in (direction of arrow B).

6. Turn backrest adjustment wheel 120° further.
7. Hook assembly tool3399 in and lever in (direction of arrow B).
8. Remove backrest adjustment wheel.
9. Move seat to uppermost position.
10. Remove expanding rivet (2) for trim (1).
11. Open clips (4) (2 clips).
12. Unclip trim (1) from retainer (3).
13. Detach trim in area of backrest adjustment wheel on backrest and seat fitting.
14. Pull trim off retainer (3) forwards and upwards. [Note: When pulling the trim off, make sure that the retainer (5) and lug (2) are not damaged.]
15. Pull electric connector (4) off driver seat lumbar support adjustment switch E176(1).
16. Remove trim. [Note: Ensure that the lug (2) is seated correctly.Make sure that the trim (1) has engaged correctly on the retainer (3) and that the lockable clips (4) are closed.] [Note: Make sure that the cable is as close as possible to the connector (4).]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing B-pillar trims (2-door models) – VW · 1 torque figures
• Removing and installing alternator, 1.4 l, 132 kW TSI engine
• Removing and installing alternator, 2.0 l, 162 kW TSI engine
• Removing and installing fresh air and air recirculation flap control motor V154
• Filling: Using cooling system charge unitVAS 6096 only